丝网印刷中的绷网参数.docVIP

丝网印刷中的绷网参数 The tension and the network parameters In the mesh screen, wire diameter and mesh textile pattern and the selection of materials directly affect the mesh size of the tension, the tension and the network, is measured according to the tension of these parameters on the screen, measuring the tension, tension is detected from the network box side should 10 centimeters, or measured the tension is not accurate. SEFEN PET 1000 mesh can achieve maximum value in a table. The maximum tension value is the specific intensity of the screen to display the table, namely all kinds of mesh, the maximum tensile force of different wire diameter can withstand and rebound value, if more than the given in the table of tension mesh will lose elasticity, become plastic deformation, which should be paid attention to in the tension and the network. Tension unit: Newton / cm (N/CM), available Newton tensiometer measurement. The tensiometer can measure the warp and weft tension. The screen of the warp tension is the whole roll screen winding direction tension, namely the edge direction of the wire tension type; weft tension is the tension on the screen width. The tension can be seen in the table, the same kind of material for different wire diameter, different mesh size of the screen, the tension is different, which is the same mesh size of the screen, the tension is different, which is the same mesh size of the screen, wire diameter, the tension is different, because tensile is with the wire diameter is proportional. For example: A B is 2 times the wire radius, then the tensile strength of A wire is B wire 4 times. In the table the tension value of high strength of side length of about 1 meters below the frame effectively, when the edge length of 2 meters of the screen frame, then tension values should be reduced to 15%-20%, if the network box up to 3 meters, the tension and the network, according to the table given in the tension reducing 20-25%. In order to ensure the processing