- 31
- 0
- 约3.89万字
- 约 10页
- 2017-10-22 发布于湖北
- 举报
2017年 4 月 电 工 技 术 学 报 V 〇1.32 Na7
第 32 卷 第 7 期 TRANSACTIONS OF CHINA ELECTROTECHNICAL SOCIETY Apr. 2017
带恒功率负载的光伏-储能混合发电系统
非线性行为分析
韦 李 军 黄 萌 孙 建 军 查 晓 明
(武汉大学电气工程学院武汉430072)
摘 要 由于光伏-储能混合发电系统存在多种工作模式以及负载变换器的恒功率特性,系统在多个
模式下出现不稳定性运行行为。首先识别系统中的霍普分岔和灾难性分岔的不稳定现象;然后通过建
立系统开关平均模型,结合大信号分析,解析性地给出了系统非线性分岔行为的物理机理;最后通过
计算和电路仿真,给出了保证实际系统能够稳定运行的参数变化范围。实验结果验证了分岔分析和稳
定区域的正确性。
关键词 :光伏-储能混合发电系统恒功率负载分岔现象稳定性分析
中图分类号:TM46
Nonlinear Analysis of Photovoltaic Battery Hybrid Power
System with Constant Power Loads
Wei Lijun Huang Meng Sun Jianjun Zha X iaom ing
( School of Electrical Engineering Wuhan University Wuhan 430072 China )
Abstract Due to the multiple operating modes of the photovoltaic-battery hybrid power system and constant
power characteristic of load converters , there could be various instabilities in the system under different modes . In
this paper , the instability phenomena of Hopf bifurcation and catastrophic bifurcation are identified in this kind of
system firstly . Then , the physical origin of the nonlinear dynamics are analytically found by applying the
switching averaged modeling and the large-signal analysis . The stability regions of the system parameters are given
by mathematical calculation and circuit simulation . The validity of bifurcation analysis and the stability regions
are verified by experimental works .
Keywords : Photovoltaic-battery hybrid power system , constant power load , bifurcation phenomena ,
stability analysis
〇 引言 光伏-储能混合发电系统可由光伏电池板和蓄电池
通过功率变换器相互组合,并
您可能关注的文档
- 北斗导航定位服务性能时空特性分析.pdf
- 北京城区就医可达性评价及空间特征分析.pdf
- 北京市外来老年人口时空演化特征及影响因素分析.pdf
- 鼻咽癌外周血IL-2、IL-10水平与其放化疗敏感性的相关性分析.pdf
- 病例-对照设计的似然比罕见变异关联性检验的构建和模拟评价.pdf
- 玻璃化冻融囊胚助孕妊娠妇女娩出胎盘Grb10表达分析研究.pdf
- 剥落型矿柱与早强胶结充填体相互作用损伤演化分析.pdf
- 不同产地紫芝子实体中活性成分的测定分析.pdf
- 不同脆化阶段草鱼肌肉的显微结构观察和质构特性分析.pdf
- 不同耕种作物下土壤挥发性成分SPME-GCMS分析.pdf
- 高校innovations助推经济发展案例解析.docx
- 《紧固件 2型六角螺母 细牙》国家标准修订发展报告.docx
- 《紧固件 六角薄螺母 细牙》国家标准修订发展报告.docx
- 《产品几何技术规范(GPS) 尺寸测量设备 参考盘规》国家标准立项与发展报告.docx
- 《紧固件 1型六角螺母》国家标准修订发展报告.docx
- 《紧固件 六角薄螺母》国家标准修订发展报告.docx
- 《航空器杠杆开关 性能要求 第1部分:Ⅰ类和Ⅱ类》标准化发展报告.docx
- 《氮化铝单晶位错密度测试方法》标准立项与发展报告.docx
- 《无损检测 超声导波检测 第3部分:相控阵法》国家标准立项与发展报告.docx
- 《产品几何技术规范(GPS) 表面结构:轮廓法 第2部分:术语、定义及表面结构参数》国家标准立项与发展报告.docx
原创力文档

文档评论(0)