中学教育（Secondary School Education）.docVIP

中学教育（Secondary School Education） Brief introduction of EDA training experience: In April of this year, the school carried out the FPGA training board according to the requirements of our specialized EDA technology and our other course Experience EDA training experience beginning in April of this year, the school according to our major EDA technology needs with our other class electronic products installed in combination were assembled FPGA training board, training place at S12-201, the main training process has two parts, one part is the assembly of SMT surface mount components the part is the welding of the THT element in the course of the training I learned many do not understand the past experience, and more understanding of the book difficult to understand some knowledge points. The beginning teacher put a THT element of our own, we first check the components if there is a problem, I did not grasp the detection element points at the beginning, Nawan table meal chaos, simply can not be measured in the end there is no problem, but later by and ask the same teachers advice, I I learned the basic element detection, detection of end components for the next welding to save a lot of time and effort, we can avoid the problem because the element itself from the new welding. After test components, the teacher said to let us know more about the pipeline operations, mount SMT components on the use of pipeline operations, 11 station I is responsible for the patch, I thought it was easy, did not care too much, really to the assembly line when I here, my tweezers resistance is hand away but then, I remember the teacher said to the point, calm down, after a few mount down slowly familiar with, is no longer nervous, the whole process down although we are very serious but still have many problems, but after the welding, basically is not successful, this part is completed after, behind the basic is their own team members assembled, Hu Jing and I are respectively welded part, after