UT探伤通用规程的知识.doc

超声波探伤通用规程 检验规程内容： Content 1.0适用范围/scope 2.0参考规范/reference 3.0检验人员/ NDT-Personnel 4.0超声波检测/ Ultrasonic testing 5.0检验报告/Examination report 1.0 适用范围 / scope 本规范是铸件的检验规程和验收标准。本规范覆盖检验区域。 This specification is the inspection procedures and acceptance criteria of casting. Inspection areas are covered by this specification. 2.0参考规范/reference GB9445-99：中国机械工程无损检测学会无损检测人员资格及鉴定/non-destructive testing institution of the Chinese mechanical engineering society qualification and certification of NDT personnel EN473 ： NDT 无损探伤试验人员的资格和资格证--总则/ qualification and certification of NDT personnel—general principles. SNT-TC-1A：无损探伤人员资质/ qualification and certification of NDT personnel EN12680-3：铸造-超声探伤-第3部分:球墨铸铁/Founding-Ultrasonic examination -part 3: Spherical graphite cast iron castings. ISO 8501-1：表面粗糙度/visual assessment of surface cleanliness 993062：超声波设备的校准/Ultrasonic equipment calibration and verification EN12668－1：无损检测－超声设备的特点和验证－第1部分：仪表。 EN 12668-1：Non-destructive testing - Characterization and verification of ultrasonic examination equipment - Part 1: instruments. EN12668－3：无损检测－超声设备的特点和验证－第3部分：设备组合。 EN 12668-3：Non-destructive testing - Characterization and verification of ultrasonic examination equipment - Part 3: Combined equipment. EN12223：无损检测－超声检测－校准试块No.1的规范。 EN 12223：None destructive testing – Ultrasonic examination - Specification of calibration block no.1. 3.0检验人员/ NDT-Personnel NDT人员至少应获得一个下述标准证书的认证： NDT-Personnel must be qualified to one of the following certification standards: GB9445-99：中国机械工程无损检测学会无损检测人员资格及鉴定/nondestructive testing institution of the Chinese mechanical engineering society qualification and certification of NDT personnel EN473 ： NDT 无损探伤试验人员的资格和资格证--总则/ qualification and certification of NDT personnel—general principles. SNT-TC-1A：无损探伤人员资质/ qualification and certification of NDT personnel 根据EN 473 或ASNT SNT-TC-1A的规定，所有无损试验的检验员，都要经过培训达到2级的资质水平。他们若不够2级水平，则应在2级甚至3级资质水平的人员指导下工作。供货方的3级人员，应定期培训自己的NDT工作人员。 All NDT inspectors must be t