化油器保养（Carburetor maintenance）.docVIP

化油器保养（Carburetor maintenance） Disassembly and adjustment method of the carburetor first remove the carburetor and air filter, filter cleaning or replacement of the filter, remove the carburetor cleaning check main hole, idle hole and air hole, adjust the float chamber to the normal level, the oil needle card to the last frame, then refitted carburetor and air filter, start the vehicle, a car preheat 2-3 minutes, adjust the plunger height adjusting screw to the idle speed is minimum, and then adjust the engine speed to idle air adjust screw top, and then adjust the plunger adjustment screw to the idle speed is minimum, and then adjust the idle air adjusting screw to the highest speed, repeated several times until the piston position adjustment, the lowest and highest engine speed and operation smooth, is adjusted to the best position. Slow throttle, engine speed should be smooth up the throttle in any opening on the block, or remove the oil needle cards downward, until satisfied. How long should the carburetor repair? Long time (more than one week) without the use of a motorcycle engine or, be sure to put the net residual oil in the carburetor, so as to avoid residual oil deterioration of corrosion of copper parts, resulting in failure carburetor. 1. regular inspection, carburetor cleaning and maintenance, in general, should be looking for an experienced professional maintenance staff is better to avoid self repair untune. 2. non professionals, carburetor idle screw (PS) do not adjust. 3. T sub chamber carburetor oil factory have a high degree of fine adjustment qualified, not to adjust, so as not to lead to failure (oil, black smoke, oil poor etc.). Do not use 4. carburetor long time, should be put in the net float chamber oil storage, to prevent the deterioration of gasoline and glue, plugging the hole and the volume of oil, causing the carburetor scrapped. 5. carburetor cleaning, do not use metal wire poke out all or a small amount of pore channels. Application of