ret t（RET T）.doc

ret t（RET T） There are three steps to software installation. Double click the compressed package after downloading, and then open the file inside, as shown below: Figure 1 installation steps for Total Recorder Total Recorder installation has three steps, followed by: installation of the main program, external encoder and registration. The concrete steps are as follows: (1) open the compressed package, double-click the installer.Exe, and run the installer. This is a simple step, and you keep setting the next step. After installation, press the prompt to restart the computer. Its a simple step. I dont map here. (2) re open the compressed packet, double-click the external encoder.Exe to complete the installation of the MP3 encoder. (3) or in this compressed package, double-click cr.reg, the registration information into the registry, complete registration. So far, the software installation of Total Recorder has been completed and a new icon will appear on the desktop. Double click on the icon on the desktop, you can start Total Recorder, which works as the main interface is as follows: Figure 2 the main interface of Total Recorder 2, software settings Total Recorder starts recording before you start using it without having to do anything. But in order to maximize its effectiveness, it is recommended to do the following: Click the options / Settings on the menu, and then a card setting interface pops up. Most of the settings for Total Recorder are here. (1) select the card MP3, and select LAME encoder in the drop-down menu of select MP3 encoding program. See below: Figure 3 MP3 encoder settings (2) select the card open / save. Set temporary folders and default open / save folders needed for system work. Following chart: Figure 4 sets the temporary folder and the default open / save folder when the system works. These two folders are best placed on the largest hard disk partition, so as not to block the space on the system disk where the operating system is located. For