写真机维护（Photo machine maintenance）.docVIP

写真机维护（Photo machine maintenance） 4. after cleaning for re inserted ink tube and liquid level sensor signal line, and then continue to print jobs previously suspended. Five. The above treatment methods have little effect or temporary no effect when the treatment method 1. remove the nozzle from the showerhead tray. 2. in clean glass containers (for example: in the beaker) into the amount of special cleaning fluid, to put the nozzle submerged nozzle at the bottom of the 2~3mm is appropriate, then the glass container is sealed with plastic film (dust) standing for more than 1 days. Note: the signal interface at the top of the nozzle must not touch the cleaning solution, otherwise it will damage the nozzle. 3. nozzle after soaking, into the amount of special cleaning fluid in the printer head cleaner, and then put into the cleaning liquid immersion nozzle at the bottom of about 2~3mm, and then start the washer nozzle washer, choose special, if using the general ultrasonic cleaner must strictly control the time, in order to prevent damage to the nozzle. Note: the continuous use of cleaning, cleaning should not exceed three times. 4. glass syringe extraction 40ml special cleaning fluid, the interface to the upper part of the ink injected from the nozzle tube, observe the state of the nozzle from the waterline, if all of the waterline are very straight, that cleaning is effective, the nozzle can continue to use (the premise: circuit and piezoelectric crystals are intact, if there are still) part water spray should be crooked, according to the second, third steps to do 2~3. Six. Equipment is expected to be more than 48 hours, temporary treatment method is not used. If the device is expected to be more than 48 hours is not in use, the ink cleaning nozzle must be clean, otherwise the ink in the nozzle for gradual solvent evaporation and dry, serious or even caused irreversible damage to the nozzle. The processing method is as follows: 1. turn off the power of the photo machin