如何解决石材地缝高低差（How to solve the gap between stone and stone）.docVIP

如何解决石材地缝高低差（How to solve the gap between stone and stone） A production problem in practice With the continuous development of our national economy and the strength of the national economy continues to improve, the utility of natural stone ground with decorative features and durable luxury, although expensive, but still widely used in large public buildings in many new lobbies, corridors and other public areas. But the stone floor seam height difference is always a quality problem, especially in the stone block size more than 900 mm joints or are significantly. For the quality defects of some site by artificial local flat polishing again control, but because of artificial tool capacity constraints, often formed at the edge of the side seams, affect the overall appearance of the ground; some sites by heavy local pressure adjustment, but the amount is very small, many people spend. Aiming at the quality problems, some testing, found the stone paved, flat are not in the four corners and the adjacent stone, the stone itself is not high flatness is caused by the joints or the great difference of the reason. There are two main reasons for the uneven stone ground joint The performance of 1, stone is not uniform There are great differences in physical and chemical properties of different varieties of stone of the chemical composition, porosity, water absorption, even in the same mining mining blocks, buried depth is deeper, the greater the stress of orebody. The release of internal stress is a slow process, if the quarry soon after being processed into sheets, the deformation is the release of internal stress will cause the plate. Large plates piled in after processing and transportation will produce deformation. There are varieties of stone by large deformation, water wet, such as big flower green is wet after deformation of arch. So all kinds of differences, comprehensive stone moisture absorption caused by deformation and many other reasons, to make the building plane pla