发电机组(电球)一般故障及排除方法（General faults and troubleshooting methods of generator sets (electric balls)）.docVIP

发电机组(电球)一般故障及排除方法（General faults and troubleshooting methods of generator sets (electric balls)） General faults and troubleshooting methods of generator sets (electric balls) 1, generator (electric ball) missing magnetism is how, what should be done? Answer: generator (electric ball) long moment without cause, including remanence in the core of the factory before going missing, not due to the excitation coil made of magnetic field, when the engine is operating normally but no electricity, this kind of phenomenon of new machines or without the unit more. Disposal style: 1) press the excitation button with the excitation button. 2) without excitation button, use the battery to magnetize it. 3) bring a light load, speeding for a few seconds. 2, what kind of energy does electric energy belong to? What are the characteristics of alternating current? Answer: power belongs to the two level of energy, alternating current from mechanical energy conversion, DC power from chemical energy conversion, alternating current characteristics can not be stored, and now found to use. 3, why the generator (electric ball) must ensure the cleanliness of the warehouse, no dust floating on the ground? Answer: if the diesel engine inhaled dirty air will make the power decline; if the generator inhaled sand, dust and other impurities, will make the gap between the stator and rotor insulation damage, which led to destruction. 4, cause high water temperature, alarm stop, and even can not control, what are the reasons? Answer: water tank leakage or water is not enough; water temperature sensor damaged; water tank dirt too thick or too much heat radiation oil; The fan belt wear is too large, the pressure is not enough; the abrasion of the pump, the water pump is not enough; the thermostat opening angle is not enough, there are card dead phenomenon; cylinder gasket destroyed, waterway and similar cylinder; cylinder wear too much, not suitable for local seepage; room ventilation requirements; engin