szgc0104（szgc0104）.docVIP

szgc0104（szgc0104） 1K411040 urban road surface layer construction 1K411041 is the master of asphalt surface construction technology Master of 1K411042 modified asphalt mixture layer construction technology 1K411043 master cement concrete pavement construction technology 1K411044 familiar with the major technical points of urban road maintenance 1K411041 is the master of asphalt surface construction technology I. construction preparation (1) penetration and adhesion; 1. asphalt mixture layer should be on the surface of spray priming oil in fully penetrated oil layer at the grass-roots level before paving layer. During construction, liquid permeable asphalt and emulsified asphalt should be chosen according to the type of base layer to make the coating oil. 2. double layer or multilayer heat hot mix asphalt mixture layer between the adhesive layer should be sprayed with oil, or in the cement concrete pavement, asphalt stabilized macadam, old asphalt pavement asphalt mixture, spray adhesive layer oil. Quick or medium splitting emulsified bitumen or modified emulsified bitumen should be adopted, or fast or medium pour liquid petroleum can be used as adhesive oil. 3. urban road construction and acceptance specification CJJ 1 mandatory provisions: the construction of asphalt mixture surface shall not in rain and snow weather and environmental temperature lower than 5 DEG C. (two) transportation and cloth 1. in order to prevent the asphalt mixture bonded truck compartment plate, before filling should be sprayed with a thin layer of isolation agent or anti caking agent. In the transportation of asphalt mixture should be used tarpaulin covering insulation, rain and pollution prevention. 2. lorry tyres shall not be stained with dirt and dirt may pollute the pavement construction, found that asphalt mixture does not meet the construction requirements of temperature or agglomerate into pieces, rain has not used the phenomenon. 3. should arrange transportation and cloth according