多级注射控制（Multi-stage injection control）.docVIP

多级注射控制（Multi-stage injection control） Modern injection molding products have been widely used in various fields, the shape of the products is very complex, and the properties of polymers used are very different. Even if the products of the same material, due to the geometry of gating systems and different parts, different parts of the melt filling flow (velocity, pressure) of the request, otherwise it will influence the melt crystal orientation in this part of the rheological properties of polymer or quality, and products to the table. In an injection process, to promote the melt mold screw, to achieve control requirements in different positions have different parameters of different injection speed and injection pressure, the injection process is called multi-stage injection molding. Dial type injection molding machine is relatively backward, only one or two injection, a packing, a glue control procedure for the complex structure, the appearance of high quality products, it is very difficult to set and control the injection speed and other process conditions, resulting in the emergence of some defects of injection molded parts to through the improvement of method for adjusting the injection parameters. In order to meet the need to improve the appearance quality of the injection parts, to overcome these problems, the manufacture of injection molding machine development and production of the injection molding machine with multi-stage injection, multistage pressure, multi-stage melt function, this is the injection molding industry a breakthrough in technological progress. At present, most of the injection molding machines are controlled by multi-stage injection speed. Usually the injection stroke can be divided into 3 or 4 areas as shown in figure a, and the areas are set at different proper injection speeds. As shown in Figure B, the use of low speed, cavity filling, high speed filling, and low-speed injection at the end of the injection are used at the initial stage