HSC01转角油缸.pdf

HSC Hydraulic Swing Clamp Cylinder • Bore:ø25-ø63mm • Pmax:100kg/cm2 • MC • • , • 1.5 • Product Introduction • The product is ideal for mass production on a special purpose machine and jig on machining center. It will greatly upgrade production efficiency. • When the hydraulic cylinder actuate, and the piston moves downward, the clamping arm will swing to a rated angle. Then it lowers until the workpiece is clamped securely. • To avoid too fast motion a flow control valve is suggested to connect to the hydraulic swing clamp cylinder. Do not clamp workpiece while the calmp is swinging to avoid damaging on the cylinder barrel and internal parts. • When increasing length of clamping arm is required, be sure do not exceed 1.5 times of the original length. • The cylinder body is manufactured from structural carbon steel. Surface is specially treated for maximum smoothness on inside surface and long service life. Specifications Bore of cylinder mm ø25 ø32 ø40 ø50 ø63 Piston rod diameter mm ø18 ø20 ø22.4 ø28 ø35 Swing stroke mm 9 11 11 13 13 / Clamping stroke std/Incr mm 13 15 / 30 15 / 30 17 / 34 17 / 34 / Pressure area pull/push cm2 2.37 / 4.91 4.9 / 8.04 8.63 / 12.57 13.47 / 19.63 21.55 / 31.17 Theoretical clamping 30kg/cm2 71 147 259 404 647