基于flac数值模拟冲击地压矿井条带开采煤柱宽度研究 research on rockburst mine strip mining of coal pillar width based on flac numerical simulation.pdfVIP

2016 7 年第 期 1 ·安全生产技术与工艺研究 · 基于FLAC 数值 模拟冲击地压矿井条带开采煤柱宽度研究 孙学军 周 莉 ( 山东省滕东生建煤矿，山东滕州 277521 ) 摘 要 基于采区地质条件建立FLAC 数值模型，模拟冲击地压矿井采区条带开采 。对比分析工作面采90m 留60m 煤柱 与采120m 留80m 煤柱两种条带开采方案的应力分布、位移变化及煤柱塑性变化的情况。研究结果说明适当的大采留比有 利于减小煤柱的应力集中系数，缓解工作面的防冲困难，同时大采留比减少了掘进工作量，节约开采成本。 关键词 冲击地压矿井 条带开采 采留比 煤柱应力 TP391.72; TD823.6 B doi:10.3969 j.issn.1005 2801.2016.07.001 中图分类号 文献标识码 / - Research on rockburst mine strip mining of coal pillar width based on FLAC numerical simulation Sun Xue-jun Zhou li (Shandongsheng Tengdongshengjian Coal Mine,Shandong Tengzhou 277521) Abstract:Based on the geological conditions of mining area establish a FLAC numerical model, simulation of mining area of strip mining of rockburst mine. Comparative analysis of mining face 90m leave 60m pillar and mining face 120m leave 80m coal pillar two strip mining scheme, the change of displacement and stress distribution and plastic changes of coal pillar . The study results show that leave appropriate large coal pillar is conducive to reducing stress concentration factor alleviate the prevention of rockburst difficult of working face, at the same time large coal pillar reduce the tunneling work, save the production cost. Key words: rockburst in coal mine strip mining mining ratio stress of coal pillar 1 条带开采回采数值模拟 90m 留 60m 煤 柱 开 采 方 案， 对 301、302、302 和 304 四个工作面做回采模拟分析。建立模型大小 1.1 采区概况 640 ×204m ， 山 东 省 滕 东 生 建 煤 矿 3 采 区 南 北 走 向 长 约