现浇板厚度选取（Thickness selection of cast-in-place slab）.doc

现浇板厚度选取（Thickness selection of cast-in-place slab） The thickness of the one-way plate is not less than 1/30L, the two-way plate is not less than 1/35L, and the minimum thickness of the floor panel is not less than 90mm, and the minimum thickness of the roof plate is not less than 100mm. The slab thickness of adjacent cast in place shall not be more than 30mm Provisions for reinforcement of cast-in-place slabs: (1) the reinforcement of cast-in-place slab shall be designed according to the principle of fine reinforcement. (2) the cast-in-place slab shall be controlled with a minimum reinforcement ratio greater than 0.25%. (3) the plate near the gable should be equipped with double layers of reinforcing steel mesh. Adding radial reinforcement at the corner of the wall. In the region where the temperature and shrinkage stress are greater, a double layer steel mesh should be installed. (4) double reinforcement shall be adopted for roof bar reinforcement. (5) double deck two-way steel bars shall be installed in cast-in-place slabs with a thickness of more than 120mm. Residential construction expansion joints and concrete components, protective layer thickness should be strictly in accordance with the provisions of the corresponding norms. Longitudinal length of longer (generally more than 40m) of the building can be used after the treatment of the casting belt, or can be in the house every 20m or so on the plate on the support (sub households, partitions) to sew. The cast-in-place concrete plate can compensate the shrinkage of concrete by adding a proper amount of admixture. When the strength grade of cast-in-place concrete slab is more than C30, priority should be given to the use of high performance concrete. The crack control of cast-in-place slab should be based on the characteristics of its structure and structure, and should be strengthened by the principle of structure strengthening and releasing stress when necessary. In the design of cast-in-place slab, crack con