信号分析仪FSIQ26使用.pptVIP

信号分析仪FSIQ26使用 1,FSIQ26的基本操作说明 1.display screen 2.softkeys 4. MAR:select and set marker NORMAL: select and set the marker; SEARCH: set and start the peak/min search; DELTA: set the delta markers; 5.FREQUENCY 7.LEVEL: define reference levels and display the range in the active windows 8.DATA ENTRY 10.DATA VARIATION 12.INPUT: set the impedance and attenuation at the RF input 13.RF INPUT 1 14.PROBE/CODE: power supply and coded socket for RS accessories. 15. SWEEP AREA TRIGGER: set trigger source.the led illuminates on valid trigger COUPING: set coupled parameters: RBW,VBW,SWT. 24.ON/STANDBY SWITCH in the standby mode, the AC line voltage is still present with the instrument. 2, FSIQ26使用注意事项 #1,RF INPUT 1 maximum DC voltage is 0, the maximum power is 1w（30dB). #2,RF INPUT port is a special port, a N-type port adapter, should be protected #3, before turning it on, note the following: signal levels at the input connectors are all within specified maximums; signal outputs are correctly connected and not overloaded. #4, the power plug must be plugged into an outlet that provide protective earth ground connection 3,FSIQ26的测试功能 Level and frequency measures Measure of harmonic Measures of intermodulation distortions Time-domain measures with pulsed signals For the IDEN, it can be used for testing the phase noise, harmonic . 4,基本测试实操（如phase noise) * 1,FSIQ26的基本操作说明 2, FSIQ26使用注意事项 3, FSIQ26 测试功能 4, 基本测试实操 Front Panel view RS FSIQ26 DUT * * *