高压控制油控制单元.pptVIP

HP Hydraulic Block ?Rexroth“ ?Rexroth“高压控制油集成装置 HP Hydraulic Block ?Rexroth“ ?Rexroth“高压控制油集成装置实物 HP Hydraulic Block ?Rexroth“ HP Control Oil Unit consists of:高压控制油装置组成包括如下: 2 pcs of HP oil pumps A10 VSO – 1 in operation, 1 as 100% stand-by （两台100%容量高压油泵，机组运行时一备一用 Duplex filter at HP oil pumps discharge 高压油泵出口的双联滤油器 Accumulator 蓄能器 Auxiliary oil pump of by-pass filtering and cooling辅助循环油泵(带冷却器及风扇） Oil cooler and fan冷油器及风扇 Heater 加热器 High Pressure Hydraulic Block With Safety Block “2-OUT-OF-3”带三选二安全模块的高压控制系统 HP Oil Pump A10 VSO高压油泵 HP oil pump A10 VSO HP Oil Filter at HP Oil pump discharge高压油泵出口的高压油滤网 Accumulator and Electric Heater蓄能器及电加热器 Auxiliary oil pump of by-pass filtering and cooling 辅助油泵系统 Oil Filter and Cooling Circuit滤油器及冷却回路 Safety Block for 2-out-of-3三选二安全模块 Safety Block for 2-out-of-3三选二安全模块 Safety Block for 2-out-of-3三选二安全模块 Safety Block for 2-out-of-3三选二安全模块 Safety Block for 2-out-of-3三选二安全模块 Power Generation | Industrial Applications * 09/2007 Siemens Power GenerationIndustrial Applications Titel Siemens Power GenerationIndustrial ApplicationsSteam Turbines References Training Documentation of KAIDI WUHAN Turbine 武汉凯迪汽轮机培训教材 Code Word TG1-7 (5745-51) HP CONTROL OIL UNIT 高压控制油控制单元 HP oil to Control Valves控制油至调门 HP trip oil to ESV安全油至主汽门 Drain from valves阀门回油 Δp = 5 bar Δp = 2,2 bar 冷油器及风扇(自动运行) Charakteristics of HP oil pump P (bar) Q (%) 高压油泵出口油压调试时调整到140bar Max. Δ p = 5 bar Accumulator蓄能器 Nitrogen filling充氮 Appox. 90 bar (g) Electric Heater 电加热器 Suction 抽入 Discharge 排出 Oil filter油滤网 : 5 μm Max. Δp: 最大压差 2,2 bar Fan and Cooler 风扇及冷却器 三个电磁阀都带电的状态 一个电磁阀失电的状态 二个电磁阀失电的状态 三个电磁阀都失电的状态 THE END THANK YOU 滤油器上部有个按钮，在压差超过0.5MPa时弹出，此时DCS画面报警；运行人员应切换滤网，并通知检修清理滤网 油压低于0.9MPa时，蓄能器动作，维持或延缓油压下降 注意：冷却风扇投自动后：油温＞55℃或冷却油泵运行时，自动投入；油温＜50℃或冷却油泵停运时，自动退出； 电磁阀带电运行，失电跳闸，跳闸信号3取2 注：高压油滤油器压差正常运行时应小于0.22MPa，≥0.22MPaDCS报警 Power Generation | Industrial Applica