被动防护网安装施工工艺说明（Construction process description of passive protective net installation）.docVIP

被动防护网安装施工工艺说明（Construction process description of passive protective net installation） 1) measure and fix the steel column and anchor bolt foundation according to the design and the actual terrain. The line length should be increased by approximately 3 to 8% than the length of the system design, system layout of difficult terrain along the same contour in a straight line arrangement when taking the upper limit (8%); the terrain is smooth and regular, systematic layout can basically in the same contour along a straight line layout to take lower (3%); on the basis of on the column spacing can be designed for spacing of 20% shortening and widening scope of adjustment. (2) (excavation of overburden layer is not thick, when the excavation to the bedrock and has not yet reached the design depth, is located in the foundation pit of the anchor hole drilling bolt holes, to be inserted into the bedrock and anchor grouting after perfusion of the upper foundation concrete). (3) burying the anchor bolt and pouring the foundation concrete (for rock foundation, the 2 and 3 working procedures shall be drilling, bolt hole and anchor rod installation, and the concrete foundation can also be drilled and drilled after installing the foundation concrete.). (4) base mounting: insert the base into the anchor bolt and screw down with the nut. (5) installation of steel column and anchor rope; A. place the steel column up and down, and make the bottom of the steel column at the base; B. will pull the anchor rope hanging ring on top of one hanging seat, the other end will then pull the anchor rope on the corresponding anchor ring and connected with a rope card temporarily fixed (intermediate and drop anchor rope reinforcement, anchor rope is installed or above for anchor rope installation after the installation can be); C. slowly lifted the steel column and aligned it to the base, then inserted the bottom of the steel column into the base, and finally inserted into the connecting screw and ti