调音员操作（Operator operation）.doc

调音员操作（Operator operation） At present, most of the professional acoustics used in the domestic dance halls are imported equipment, and it should be said that the reliability is higher. The main problem is that the professional quality of the operator is not uniform, and there are few units equipped with qualified tuners. Therefore, often due to improper operation, resulting in poor sound effects, and even lead to damage to equipment. This article explains the key points of the audio equipment in the small and medium-sized singing and dancing hall, which can serve as a reference for the development of operating procedures. In addition, in the small dance hall as the microphone sound feedback caused by the phenomenon called self-excited whistle, is a headache for common users, because often appear howling will make guests disappointed, sound out of the question, will cause serious damage to the equipment. Therefore, the phenomenon of self-excited whistling is an important issue in the use of acoustics in the cabaret. First, sound equipment on and off order According to the order from front to rear boot, from the source device (CD, LD machine, DVD machine, tape recorders, video recorders), audio processing equipment (pressure limiter, actuator, frequency divider, equalizer effects, etc.) to the audio power amplifier to TVs, projectors, monitors. When the power is switched off, the power amplifier should be turned off first. This operation prevents the opening and closing of the device and prevents burnout of power amplifiers and speakers. Two, the preparation before singing - debugging 1. of the power will be transferred to the position of maximum volume control potentiometer; mixer accompaniment music and microphone fader shunt should be placed in the 0dB; the GAIN shunt mixer input gain are put in the tuned position; mixer total volume fader to the minimum position (lower); console sound compensation knobs are placed in the middle position. 2. test accompaniment chann