硬盘重要测试简介（Hard disk test introduction）.docVIP

硬盘重要测试简介（Hard disk test introduction） Hard disk test introduction The part of the general hard disk drive, from the beginning of the design to the completion of a usable product The parameter control value is many, must pass the unceasing analysis, the test, can have the quality to achieve the mass production Possibility of change. The test can be roughly divided into Level (Component) and the disk machine body (Drive, Level) two aspects, such as a brief description: 1-1 component aspects (Component, Level) 1. motor measurements (Spindle, Motor, Measurements) (1) axial and radial repeatability and non repetitive vibration (Axial, Radial, RO/NRRO): Main If the Sensor (Fotonic) or other micro displacement sensors are used to measure its specifications Probably around 0.005mm (RRO) and 0.00038mm (NRRO). (2) magnetic leakage (Magnetic, Flux, Leakage): Gauss Meter (Gauss) is used as an example Measuring motor outside line, the biggest specification is 2Gauss. (3) the resistance of an armature coil (Armature, Coil, Resistance): for example, its resistance size is approximately 5.0-5.7Ohms, and the error value of the two phases is less than 0.1Ohms. (4) noise (Acoustic Noise): such as the use of noise in the motor above about one meters, the amount of Its value should not be greater than 27dBA. (5) starting torque (Start, Torque): for example, at any angle of the motor, under the 0.61Amps The starting torque must be at least 0.49oz-in. (6) rotating current (Running Current): for example, in normal operation, the rotation current changes Different amounts must be within a certain range. (7) inductance values (Inductance), such as in-service measurements at 1 KHz, 1 Volt, and 0 Bias Three-phase inductance. (8) Voltage EMF (Back): for example, when measuring motor rotation, its back electromotive force The voltage value and the ripple size is in accordance with the specifications. (9) speed (Spin, Speed): for example, measuring motor speed error is less than 1/1000. (10) bala