VC15校准器使用说明书（E100001）-Metravi.DOCVIP

METRAVI 15 CALIBRATOR OPERATION MANUAL VOLTAGE / mA CALIBRATOR SAFETY INFORMATION The following safety signs for operation are used through out the manual.. !WARNNING . !CAUTION The instrument was not operated correctly, injury both to the calibrator or the operator might occur . NOTE Short annotation or additional explaination . To avoid electric shock, injury or damage to the calibrator or operator , please follow the safety instruction !WARNNING ?Operate in gas：DO NOT operate the instrument under the condition where combustible gas, explosive gas , dust and steam exists. it’s extremely dangerous. ·Operation：DO NOT apply voltage over 30V to any two terminals and between terminal and GND. !CAUTION ·Disassembly：Only authorized and qualified operator is allowed to disassemble the unit. ·Cleaning：Periodically wipe the case with a damp cloth and detergent, do not use abrasives and solvents. NOTE ·Operation：To gurantee the accuracy, the instrument should be warmed up for at least 5 minutes after power up. ·Operation：When not operate the instrument, its better to turn off the power or set it to OFF position,thats the battery life can be longer; When output curent, its better to use outside 24VDC power to make the battery life is longer. ·Operation：If the user has special requirement on accuracy, please contact us. PANNEL DESCRIPTION LCD displaying desciption OUTPUT : when pressing〔INPUT/OUTPUT〕key, display will show the required mode as OUTPUT INPUT : when pressing〔INPUT/OUTPUT〕key, display will show the required mode as INPUT CAL : Flashing CAL indicates Calibration mode is on. 0 FS : In CAL mode, it refers zero-scale or full-scale of current calibration : Low battery sign, new battery replacement is required .（see paragraph 3.1） ( : The output prompt position V、mA 、% : The unit of input/output value ON,OFF : Input or output active or on REPLACING BATTERY AND F