温度读取（Temperature reading）.docVIP

温度读取（Temperature reading） 1: Master, weinview touch screen MT6070iH communication port COM1 interface RS485 9600 2W frequency 8 data bits parity Even stop bit 1Bit 2: from the station, OMRON temperature control instrument, E4EZ communication using MODBUS RTU protocol, instrument settings, parameters and touch screen to keep in line Now read the temperature display on the meter, read the temperature control table display value of the address of MODBUS (temperature table address), 4 bytes for 0000, 2 bytes for 2000, with 2 bytes to do, the instruction frame format for 010320000001 CRC in the weinview touch screen selection software PLC Free protcol (OUTPORT INPORT and weinview touch screen application of these 2 instructions only protocol PLC or optional Free compiler error), with macro program is as follows Macro_command, main () Char, command[32], response[32] Short, address, checksum Short, read_no, return_value, read_data[1] FILL (command[0], 0,32) FILL (response[0], 0,32) Command[0]=0x1 Command[1]=0x3 Address=2000 HIBYTE (address, command[2]) LOBYTE (address, command[3]) Read_no=1 HIBYTE (read_no, command[4]) LOBYTE (read_no, command[5]) CRC (command[0], checksum, 6) LOBYTE (checksum, command[6]) HIBYTE (chrcksumm, command[7]) OUTPORT (command[0], Free, protocol, 8) INPORT (response[0], Free, protocol), 7, return_value) If (return_value0, and, response[1]==0x3) then Read_data[0]=response[4]+ (response[3]8) SetData (read_data[0], Local, HMI), LW, 0,1) End if End macro_command At compile time, display compiled successfully, doing online simulation is displayed on the digital temperature control meter, can not be displayed on the computer (in communication with the computer with communication converter RS232/RS485 temperature controller with 2 wire transmission. Do OMRON temperature control meter E5EZ and weinview touch screen MT6070iH MODBUS RTU communication 1: communication settings, COM1 96008, E 1 (same as instrument settings) 2: in the touch-screen PLC, select