万用表1（Multimeter 1）.docVIP

万用表1（Multimeter 1） Directions for use of digital multimeter 1, buzzer function is used to do what? Answer: buzzer function, is an additional function of the meter, generally done in the 2K file, is generally measured when the resistance value of less than 50 lines (or resistance), built-in buzzer sound. This function has great effect in practice, and it can improve the working efficiency of measuring and closing the circuit. It is an essential function of electronic inspection and maintenance. 2, why does the digital multimeter fail to return zero in the 200 gear? Answer: in the 200 ohm, due to the presence of resistance line, instrument panel and contact points, so short, some mantissa is normal, the mantissa in use will be more and more, but can not be adjusted to reduce the numerical by scrubbing the circuit board, close contact point. In use, first short, and write down the value, in the measurement of minus it. 3, how to determine the multimeter is good? Answer: This is a relatively big problem, it is a better method to try every function range. When detecting, it is impossible to find the detection source first, but it is impossible for the average user to provide the standard detection source. So the general detection can be measured by qualitative and quantitative methods. The basic solution is to find the source of the test and then use it again according to the instructions. 4, how to calibrate the multimeter? Answer: multimeter and other measuring instruments, factory, the factory is adjusted, so if there is no big obvious problems, please do not adjust. Now the multimeter, the meter is generally a voltage meter, so to proofread the other gear, we must first adjust the DC voltage, which is a basic file insiders said, this one a quasi, every one, every function (basically, have resistance profile except) possible misalignment. The general multimeter sets a potentiometer (such as a DC voltage gear) or a plurality of potentiometers (such as a temperature pro