亭发电厂11号炉炉膛出口烟气偏差改造实效 [ 日期2005-06-...（Effectiveness of flue gas deviation correction at No. 11 boiler furnace at Ting power plant [date 2005-06-...）.docVIP

亭发电厂11号炉炉膛出口烟气偏差改造实效 [ 日期2005-06-...（Effectiveness of flue gas deviation correction at No. 11 boiler furnace at Ting power plant [date 2005-06-...） Effectiveness of modification of flue gas deviation at furnace outlet at No. 11 boiler in Xiang Ting power plant [date: 2005-06-20] [from: power station] 1 Equipment Overview The No. 11 boiler of Ting Ting power plant is an imported 300MW controlled circulating boiler designed and manufactured by Shanghai boiler works in the middle of 90s. Adopting the imported technology of American combustion engineering company GE, the boiler is a control furnace with subcritical pressure and one reheat, and 5 HP medium speed grinding direct blowing pulverizing systems are equipped. The single furnace, four angle tangential combustion method, outdoor layout and full steel suspension structure are adopted. The boiler combustion system with four angle layout, concentric burner structure. The burner nozzle uses a wide range of pitch to shade ratio, which is better than a WR type. A wind through the perimeter wind, the wind cooling air nozzle perimeter, and control of fuel ignition, one or two secondary air nozzle by interval arrangement. Each burner bellow is divided into twelve layers, from bottom to top, second, fourth, sixth, eight, ten, five layers, and the air chamber is equipped with pulverized coal nozzle for the combustion air chamber. The third, fifth and 93 air chambers are heavy oil gun nozzles, and the total output of the heavy oil guns can meet the 40%BMCR load of the boiler. The two air nozzle at the top is used to control the displacement of NOx, at the bottom of the air chamber is also provided with a layer of light oil heater oil gun. Boiler burner with a counterclockwise rotation, 2#, 4# angle and 3# angle of hedge arrangement, 1# 12 is a tangent running imaginary circle diameter about 1200mm diameter, seventh CD layer two secondary air nozzle tangential 25 degrees. The burner of the primary air can swing up and down 20