去cad打印戳记方法（Go to the CAD stamp printing method）.docVIP

去cad打印戳记方法（Go to the CAD stamp printing method） One.. Remove the CAD print by AUTODESK education production stamp method If you have a map with education prints, you should use this method, have been used for education prints of the figure that the stamp is in any case can not afford to go, the only solution is to save this file as a R14 version of the DWG file (you can use AutoCAD2000 or AutoCAD2002), you can get rid of. If you are not the education version, as long as you print stamp, once inserted or cited used document element education edition software to draw (even if it is a line, there will be a problem), so he will be like a virus continuously through a simple extension to the CAD element any one of your files (in your imperceptibly). To print stamp AutoCAD education version of the infected file, you can use a simple way to remove! Through the file output interface AutoCAD, your files will be output to AutoCAD external swap file, and then through the input interface input file, no print stamp record! Through the test, DXF is the best choice. Through the DXFOUT output, and DXFIN input, can remove the stamp! Of course, DXBOUT, DXBIN and so on! 1. open any AutoCAD that is not an educational version, eitheror 2004 2. open the file that has been saved in the education version, and save as *.dxf in the file content 3. close that file, and then open the DXF file you saved just now 4. save as DWG file Remove the CAD print method of making stamp by the AUTODESK education 2009-07-16 10:411 version of the product, use AUTOCAD software to map open, save as DXF file format, then CAD shut down, note: be sure to shut down!! 2, re open the AUTOCAD software, and then open the file in the form of DXF, in the save as DWG format, OK! 3, if the AUTOCAD software opens the file in the DXF format just now, the command line prompt is invalid I suggest you use a higher version of the AUTOCAD software to open, and generally use AUTOCAD2008 or 2009, you can. Ive experienced