12大电脑使用误区（12 major computer misuse）.docVIP

12大电脑使用误区（12 major computer misuse） 12 major computer misuse.Txt Error 1: boot, first open the host, and then open the display A lot of friends use the computer, will habitually open the host first, and then open the display. They must have no idea how harmful it is to the computer. Most people have had this experience of life: when a high power appliance is switched on at home, the light suddenly flickers. This phenomenon is because when we open a high-power electric appliance, it will produce a larger impact current, leading to fluctuations in the city voltage, so that the lights flashing. The monitor belongs to a kind of high power electric appliance. If it opens the monitor after the host is turned on, the display will open a transient current in the signal line, and the current on the main board will fluctuate with it. A binary signal is transmitted inside a computer, and a change in the current is likely to turn a low current signal into a high current signal, which results in data transmission errors. If the host power quality is not pass, then voltage fluctuations may burn out power, or even damage the motherboard chipset. And if you turn on the monitor first and start the host again, the current fluctuation will be relatively small. Mistake 2: after you turn off the computer, put on a dust cover immediately Dust is the computers enemy , should be as much as possible to prevent dust into the computer. Many people have this awareness of computer protection, but they tend to dust them immediately after using the computer, which is very inappropriate. The electronic components of any appliance, including the monitor and the host, will accelerate aging at high temperatures, resulting in unstable operation of the circuit. Just shut down the computer, the chassis and display of the internal temperature is still high, there is still a lot of heat accumulation, then, if covered with dust cover, will seriously affect the cooling of the chassis and display. Therefore,