pcb低功耗（PCB low power consumption）.docVIP

pcb低功耗（PCB low power consumption） Nowadays, due to the development of science and technology, integrated circuits and computer systems are becoming more and more complex, so the design and manufacture of PCB is becoming more difficult. To accommodate this change, designers need to consider power requirements in the main design parameter table. The standard for low power logic circuits is defined as a power consumption of less than 1 per stage gate circuit. 3uW/MHz, while in analog circuits, is defined as less than 5mW. End users believe that low-power systems should meet the requirements of low power consumption. For the overall system design, power consumption in the design of the status has become increasingly important, which is the inevitable trend of the development of the electronic industry. The general trend in the electronics industry is to provide smaller, lighter and more powerful end products. At present, wireless and portable requirements have emerged in many product domains, and design tasks will become more challenging from a power point of view. The performance of battery powered products, is a single or a group of rechargeable battery can maintain the equipment for a few days, for example, has been widely applied to the Walkman player or a cellular phone. In addition, new requirements for low power consumption are being written into the green computer specification by environmental protection organizations. Desktop computers purchased by all government departments must comply with power requirements, i.e., the power consumption of any sleeping computer shall not exceed 30W. Barta, the sales manager for mobile products at VLSI technologies, points out that desktop computers have a trend toward deep green computers. These machines will suspend all operations until they are awakened by the associated excitation signal before entering the normal mode of operation, which is similar to the power-saving mode of laptop computers. The ARPA (US DoD Advanced R