pcb布线技巧谈（PCB wiring skills）.docVIP

pcb布线技巧谈（PCB wiring skills） PCB wiring skills 1, power, ground handling Even though the wiring in the whole PCB board is well done, the interference caused by the power and ground wire is not considerate, and the performance of the product will be reduced, and sometimes even the products success rate will be affected. Therefore, the power and ground wiring should be taken seriously, and the noise generated by the power supply and ground wire will be disturbed to a minimum so as to ensure the quality of the products. For each engaged in electronic product design engineers can understand the reasons between the ground wire and power line noise generated, only to reduce the suppression of noise in the statement: as everyone knows is in power and ground between the added coupling capacitor. Try to widen the power and ground wire width, is better than the power supply line, the relationship between them is: ground, power line, signal line, usually signal line width: 0.2 ~ 0.3mm, the fine width is 0.05 ~ 0.07mm, 1.2 ~ 2.5 mm power line. The digital circuit of PCB available wide to wire to form a loop, which constitute a network to use (analog circuit to not used) by a large area of copper layer with the ground, was not the place to use as a ground wire is connected with the printed board. Or made of multilayer board, power, ground wire each occupy a layer. 2 、 digital circuit and Analog Circuit CO processing Many PCB is no longer a single function circuit (digital or analog circuit), but is made up of digital circuits and analog circuits. Therefore, in wiring, it is necessary to consider the interference between them, especially the noise interference on the ground. The high frequency digital circuit, analog circuit is more sensitive to the signal lines, signal lines, high-frequency circuit device simulation as far as sensitive, to the ground, the entire PCB to the outside world only one node, so we must address the problem of total number, die within PCB, but in the inte