串口通信资料（Serial communication data）.docVIP

串口通信资料（Serial communication data） Serial communication data.Txt, I am reluctant to bully people, which can let others bully? Life is so long, wait for you a few years, count what I love, I will personally give her happiness, others I do not trust, I want you, I must find you, you are not allowed to bully him! Only I can do it all over the world! Give up on you, next life!! This article is contributed by my heart _happy DOC documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. 51 singlechip serial communication and baud rate settings, microcontroller 2010-04-11 11:24:44 read 221 comments: 0 large and small Quote The sky Eagle 51 microcontroller serial communication baud rate setting and MCS-51 MCU with a full duplex serial communication interface, can simultaneously send and receive. It can be used as UART (universal asynchronous receiver and transmitter), and can also be used as synchronous shift registers. 1. data buffer register SBUF SBUF is a dedicated register that can be addressed directly. Physically, it corresponds to two registers, that is, a transmit register, a receive register, and a CPU to write the SBUF is to modify the transmit register; the read SBUF is the read receive register. The receiver is double buffered, so that CPU can not respond to the receivers response in time without receiving the next frame data, and the data of the two frames are overlapped without reading the data from the previous frame. For transmitters, in general, double buffering is not required in order to maintain the maximum transmission rate because the CPU is active without causing overlap when transmitting. 2. status control register SCON SCON is a bitwise defined 8 bit registers, used to select and control the way of serial communication to send and receive, indicating the status of serial port, SCON can also address byte addressable byte address, 98H address bits for 98H~9FH. Its