发那科fanuc 0i系统和pc机的数据传输方法（The data transmission method of FANUC FANUC 0I system and PC）.docVIP

发那科fanuc 0i系统和pc机的数据传输方法（The data transmission method of FANUC FANUC 0I system and PC） Data transmission method FANUC 0I FANUC system and PC machine FANUC-0i numerical control system is a new generation of CNC introduced by FANUC company in the past two years. Compared with OC and OD, both hardware and software functions are greatly improved. The integrated CNC changed the original plate structure, give people a new feeling, especially a great improvement in data transmission, such as RS232 serial communication baud rate up to 19200b/s, by HSSB (high speed serial bus) is connected with the PC machine, use a memory card to realize the input and output data. With its wide application area, the data transmission function of the CNC system has attracted much attention. FANUC manual details the method of data transmission using disk machine, punch and programmer, but according to the actual situation of the domestic application of the CNC system, considering the cost and versatility, the use of disk machine, punch and programmer is not popular, such as the use of PC and CNC to achieve communication, no need of special equipment, and more convenient more economic. At present, PC communication software has many varieties, among which PCIN software is one of the widely used software in the field of numerical control in china. According to the experience of using this system, the author successfully uses PCIN software to realize the data communication between PC and FANUC-Oi. According to the situation in use, the effect is very satisfactory. 1 hardware configuration (1) FANUC-0i numerical control system. (2) more than 486 IBM compatible machines. (3) communication cable (the concrete connection of cable is shown in Figure 1). (4) SIEMENS-PCIN software 4.32 or above. 2 data communication Data communication can implement PROGRAM (part program), PARAMETER (machine tool parameter), PITCH (pitch error compensation table), MACRO (macro parameters) and OFFSET (tool offset table),