中9中九卫星升级教程 山寨卫星锅升级方法（In 9 of nine satellite upgrade method tutorial copycat satellite pot）.docVIP

中9中九卫星升级教程 山寨卫星锅升级方法（In 9 of nine satellite upgrade method tutorial copycat satellite pot） In 9 of nine satellite upgrade method graphic tutorial copycat satellite pot First, the computer and receiver connection 1, for the 9 receiver behind the needle, not connected with the level conversion board, which can be directly connected with the method, as shown below: 2, if the receiver is behind 3, 4, 5, 6 needles, in most cases need to be connected to a level conversion circuit board: (can be home-made, can also buy in Taobao, search USB RS232 TTL can) 3, the receiver behind each pin definition: whether behind the needle receiver, generally used only 3, RXD (receive data), TXD (transmit data), GND (ground), and, generally will have 2 pin VCC (+3.3v or +5v) and BL (BootLoader brush after the death of recovery, 1.65V) The receiver voltage instability, if the external panel, it is better to take the USB +5v as its power supply. Open the receiver box, the circuit can see the definition of the pin, the general circuit are marked...... If nothing is written, you can slowly determine each pin as follows: First find GND (ground), receiver power off, multimeter resistor files, measuring video plug, the outside of the metal and one of the pins is 0, resistance is GND (ground), Turn on the receiver power, and then go to the DC voltage file to measure the voltage between the other pins and the GND (ground). The voltage of the +5V or +3.3v is VCC The remaining two pins together are RXD (receive data) and TXD (send data)...... If you measure multiple +3.3v, do not know which is VCC, turn off the receiver power, use the multimeter resistor file to measure the power supply access point and the back pin, the resistance 0 is vcc. The receiver is connected to the computer, RX (receive data) to a computer or switch board TX (data transmission), TX (connection, send data) to a computer or switch board RX (receive data) is connected, sending and receiving is receiving and sending connected,