标准autocad命令（Standard AutoCAD command）.docVIP

标准autocad命令（Standard AutoCAD command） Standard AutoCAD command Command name Description options / actions Basic drawing command Line draw line C = close line, U = undo line, CR) = draw the line from the previous line or arc at the starting point Pline draw two dimensional polyline, H = set half width value, U = undo last option, W = Sets the start and end widths of the current line, A = switch To draw the arc, C = close the fold line, L = continue the previous line segment. In arc mode, A = arc angle, CE = center of circle, CL = closed with a circle, D = arc direction, L = cut Change to line drawing mode, S = three points, second points of arc Circle draw circles 2P = two endpoints based on diameter, 3P = based on circle On the three point, D = input diameter, R = input half Diameter = TTR = two tangent to a solid and a radius Arc draw an arc A = an angle, C = center point, D = start point, E = midpoint, L R = chord radius Rectangle draw a rectangle, prompt to choose two points to define the two phases of a rectangle Right vertex angle, and then Rectang will draw a closed rectangular line Ellipse draw ellipse or ellipse arc A = arc, C = select midpoint, R = by rotation finger Constant eccentricity, I = symmetry Point draws some entity entities that can be changed by Nmode and Nsize system variables The Ddptype point styles selection dialog box selects the point styles from the pattern. The point entity is drawn in the selected style Divide divides the entities into halves, and adds a notation to the selection entity, and then specifies the number of segments. default state Use point entities as tags, but blocks can be used Measure marks the specified distance between entities. B = blocks are used as markup devices. The default marker is a point entity Po1ygon draw polygons, E specify a border to draw polygons, I = inscribed polygons Donut draw circles to specify the inner diameter and outer diameter of the circle. For solid circles, The specified inner diameter is