氧化锌避雷器（Zinc Oxide arrester）.docVIP

氧化锌避雷器（Zinc Oxide arrester） classification 1. by voltage grade Zinc Oxide arresters are classified according to their rated voltage values and can be divided into three categories; High voltage category; it refers to 66KV class of Zinc Oxide arrester series products, can be roughly divided into 500kV, 220kV, 110kV, 66kV four grades. Medium voltage class; it refers to 3kV ~ 66kV (not including 66kV series products) within the scope of Zinc Oxide lightning arrester series products, can be roughly divided into 3kV, 6kV, 10kV, 35KV four voltage levels. Low voltage class; refers to the following 3KV (not including 3kV series products) Zinc Oxide arrester series products, can be broadly divided into 1kV, 0.5kV, 0.38kV, 0.22kV four voltage levels. 2. according to the nominal discharge current According to the nominal discharge current, the Zinc Oxide arrester can be divided into five categories: 20, 10, 5, 2.5 and 1.5kA. 3. by use of points Zinc Oxide arrester can be divided according to use for the system with line type, system type, power system in distribution, shunt capacitor protection, electric railway, motor and motor neutral type, type transformer neutral point of seven. 4. according to the structure The Zinc Oxide arrester can be divided into two categories according to the structure; Porcelain coat; porcelain coat Zinc Oxide arrester by anti pollution performance is divided into four grades, grade I, grade II for the ordinary type for medium pollution area (creepage distance 20mm/KV), class III for heavy pollution area (creepage distance 25mm/kV), IV for severe pollution area (creepage than the distance 31mm/kV). Composite coat; composite coat Zinc Oxide arrester is using composite silicone rubber material coat, and uses the Zinc Oxide resistance of high performance, internal use of special structure, with advanced technology and method to assembly, has the dual advantages of silicone rubber material and Zinc Oxide varistor. This series of products in addition to