油针调整（Needle adjustment）.docVIP

油针调整（Needle adjustment） The adjustment of the engine oil needle, which is the most feared job for most beginners, because the adjustment of the oil needle will affect the mixing ratio of air and fuel. If not adjusted, not only can not play the best performance of the engine, may even decrease the use of life. Here we provide some ways to refer to you to help you master the secrets of the adjustment more quickly. The adjustment order of the oil needle. When the engine is finished and the device is in the car, the first thing we need to test is the speed of the engine when it is paired with this car. To determine the speed of reaction engine at high speed and low speed state and then set the engine, in addition to let us know the basis adjustment criterion, the limit also can clearly understand this engine can withstand. When the high speed needle position is changed, all of the settings must re do correction. High speed oil needle sets high speed oil needle, also known as the main oil needle, it is set to adjust the amount of fuel into the carburetor oil. When the main oil needle is turned in, the amount of oil is reduced, and the mixture of oil and gas is thinner. On the contrary, when the main oil needle is turned out, the amount of oil is increased, and the mixed oil and gas are stronger. When adjusting the first main oil needle set at about the position, then put on the gas to let the car keep straight forward, listen to the sound of the engine from the car, if the cars speed has remained at a high speed, does not appear to decline, said your engine has not yet reached its highest speed, then this must be the main oil needle into, then do the high speed test line, showing the page to the engine overheating (over-heat) state is found to top speed when it will suddenly slow down. The said mixed oil inhaled by your gas engine is too thin, and the engine has reached its maximum working load, so we must be the main oil needle slightly exit point, is now completed the