电容计算公式（Capacitance calculation formula）.docVIP

电容计算公式（Capacitance calculation formula） Capacitance calculation formula Series and parallel capacity formula of capacitor - series and parallel voltage divider formula of capacitor 1. series formula: C = C1*C2/ (C1 + C2) 2. parallel formula C = C1+C2+C3 Supplementary part: Series partial pressure ratio - V1 = C2/ (C1 + C2) *V... The greater the capacitance, the smaller the splitting voltage, the AC DC conditions are Shunt shunt ratio - I1 = C1/ (C1 + C2) *I... The greater the capacitance, the greater the current through, of course, this is the AC condition A large capacitor is connected in parallel with a small capacitor Large capacitance due to large capacity, so the general volume is relatively large, and often use multilayer winding way, this leads to a relatively large inductance capacitance (also called equivalent series inductance English, referred to as ESL). The impedance of the inductor to the high frequency signal is very large, so the high frequency performance of the large capacitor is poor. Some of the small capacitance is just the opposite, because of the small capacity, so that the volume can be made small enough (a shortened lead, it reduces ESL, because a wire can also be seen as an inductance), and often use the structure of plate capacitor, so the small capacitance is very small so that it is ESL with the high frequency performance is very good, but because of the small capacity because of the impedance of the low frequency signal of the. So, if were going to let the low frequency and high frequency signals pass well, well use a large capacitor and go up with a small capacitor. Small capacitance usually used for CBB capacitor 0.1uF better (ceramic capacitor too), when the frequency is higher, but also smaller capacitors in parallel, such as several hundreds of pF, pF. In the digital circuit, the power supply pins generally give each chip on a capacitor in parallel to the 0.1uF (this is called capacitance decoupling capacitor, of course, can also b