电工考试判断题（Electrical examination judgement）.doc

电工考试判断题（Electrical examination judgement） Judgment question The fuse of the 1. fuse is selected as a small point to be used as an overload protection for the motor. Wrong 2. an electric motor is an electrical device that transforms electrical energy into mechanical energy. Yes 3. class III tools rely on safe, ultra-low voltage power supply and less voltage than the safe and extremely low voltage to protect against electric shock. Yes 4. class I tools not only rely on basic insulation in the prevention of electric shock, but also include an additional safety precaution. Yes 5. in the same horizontal stretcher, the wire phase sequence is: load oriented from the left side for L1, N, L2, L3; yes 6., in order to ensure the mechanical strength of wire 3 ~ 10KV lines, residential areas should not be less than aluminum conductor cross-section of 16mm2. Wrong 7. lines are selected to meet the mechanical strength, the safety of traffic and three wires allow voltage loss requirements. Yes 8. when the circuit breaker fails, the load can be pulled and closed disconnector (Dao Zha). Wrong 9., when a serious threat to personal safety occurs, it is necessary to fill out the operation order before switching off the power supply. Wrong 10., the operation of lightning switch and replacement fuse (fuse) work should be particularly careful. Wrong 11. maintenance status: refers to the equipment switch, switch in the off position, and is connected with a temporary grounding (or close grounding switch), and set up a good block, hanging signs, equipment in the maintenance state. Yes 12. cold standby state means that the switch and knife switch are in the disconnection position and the equipment is out of order. To make the equipment running, it is necessary to switch on and then switch the working state. Yes 13. hot standby state means that the knife switch is in the closing position, but the breaker (switch) is in the disconnection position, the power supply is interrupted and the equipmen