关于模糊控制器设计外文资料翻译.doc

　　关于模糊控制器设计外文资料翻译 关于模糊控制器设计外文资料翻译__离散模糊双线性系统的静态输导读：ingtheMatlabLMItoolbox.Inparisonation,sameoutputmatriceshavebeeneliminated.Finally,asimulationexampleshoefuzzybilinearsystem(DFBS);staticoutputfeedbac 中文2094字 外文资料翻译 Static Output Feedback Control for Discrete-time Fuzzy Bilinear System Abstract The paper addressed the problem of designing fuzzy static output feedback controller for T-S discrete-time fuzzy bilinear system (DFBS). Based on parallel distribute pensation method, some sufficient conditions are derived to guarantee the stability of the overall fuzzy system. The stabilization conditions are further formulated into linear matrix inequality (LMI) so that the desired controller can be easily obtained by using the Matlab LMI toolbox. In parison ation, same output matrices have been eliminated. Finally, a simulation example shoe fuzzy bilinear system (DFBS); static output feedback control; fuzzy control; linear matrix inequality (LMI) 1 Introduction It is odel is an effective tool for control of nonlinear systems odel is approximated by a set of linear local models connected by IF-THEN rules. Based on T-S model, a great number of results have been obtained on concerning analysis and controller design[1]-[11]. Most of the above results are designed based on either state feedback control or observer-based control[1]-[7].Very fee of static output feedback control is very important and must be used states are not pley available for feedback. The static output feedback control for fuzzy systems e-delay ming technique since they are bilinear matrix inequality problems. Moreover, it is noted that all of the aforementioned fuzzy systems odel s exist bets, uch better approximation of the original nonlinear systems than the linear systems [12].The research of bilinear systems has been paid a lot of attention and a series of results have been obtained[12][13].Considering the advantages of bilinear systems and fuzzy control, the fuzzy bilinear system (FBS) based on