喷粉工艺（Dusting process）.docVIP

喷粉工艺（Dusting process） Dusting process Dusting process Powder spraying, also called powder coating, is a new kind of painting process which has been developed rapidly in recent decades. The raw material used is plastic powder. As early as 40s, some countries began to study experiments, but the progress was slow. 1954 German James will use polyethylene coated fluidized bed method successfully, in 1962 the French company invented Semmes powder electrostatic spraying, powder coating is officially used in production, in recent years due to the importance of environmental protection, the powder coating has no pollution to water and atmosphere, has been developing rapidly. Powder coating process has many outstanding advantages: 1, a coating can be a thicker coating, such as coating 100~300 m coating, using ordinary general solvent coating, coating about 4~6 times, and with powder coating, you can reach this thickness at one time. The corrosion resistance of the coating is very good. 2, powder coating without solvent, no three waste pollution, improved labor hygiene conditions. 3 、 powder electrostatic spraying and other new processes, high efficiency, suitable for automatic line coating, powder utilization rate, can be recycled. 4, in addition to thermosetting epoxy, polyester, acrylic, there are a lot of thermoplastic resistant grease can be used as powder coating, such as polyethylene, polypropylene, polystyrene, fluorinated polyether, nylon, polycarbonate and all kinds of fluorine resin etc.. Powder coatings for protection of electrical and began margin, with the development of science and technology, has been widely used in the automotive industry, electrical insulation, corrosion resistant chemical pump, valve, cylinder, pipes, outside steel components, steel furniture, casting coating. Since 60s, the experimental research on powder coating has been carried out in our country and has been applied in production. It has been widely used so far. Powder coating process 1,