墙面装饰施工（Wall decoration construction）.docVIP

墙面装饰施工（Wall decoration construction） Technology process of covering wall decoration 1. wood paneling, wood paneling Structure of wood paneling, wood dado. The wall is buried in anticorrosive wood bricks, will wooden frame is fixed on the block, and then the panel nail glued or skeleton crib. Wooden keel section is 20~40 mm * 40~50 mm, wooden keel spacing is 400~600 mm. 2. wood paneling, wood dado construction process: To play the line, making wall, wooden frame, wooden frame fixed installation woodveneer, closing line installation 3. construction points (1) metope requirement is smooth. If the wall surface is smooth, the error is within 10 millimeters, and the plastering method can be adopted; if the error is more than 10 millimeters, the wood block between the wall and the keel can be added. (2) according to the panel height and the size of the room by bone nail sticks, whole or split installation, installation skirting board in wooden dado skirting board is fixed on the bottom of the mat and wooden wallboard, skirting board height 150 mm, with wood strips fixed on the clapboard on the rail. (3) to determine the size of wooden keel according to the thickness of the panel, the transverse keel generally in about 400 mm, 600 mm in the vertical keel. When the panel thickness is more than 1 millimeters, the horizontal keel spacing can be enlarged appropriately. (4) peg, the top panel to cable leveling, wood strip size should be consistent. (5) wooden dado after installation, should be immediately finishes, brushing oil again, to prevent other types of surface pollution. 4. matters needing attention Wet walls should be dry after construction, or moisture-proof treatment. One can do moistureproof layer on the wall; the two is to vent in the upper and lower left panels; three is through the wall brick overhangs, the panel, the wooden keel and a certain distance from the wall, avoid the influence of moisture on the panel. Two walls of yin and Yang corner, you must add naile