微机原理考试题目（Examination questions of Microcomputer Principle）.docVIP

微机原理考试题目（Examination questions of Microcomputer Principle） 1. the largest of the following is (B). A. (100101) 2 B. (70) 8 C. (35) 10 D. (2B) 16 The 2 decimal number 43 represents the combination (or compression) of the BCD code as ( B). 3 in the (signed number) representation, the binary number represents the decimal number (- 1) 4. in the following 80x86 instructions, the legal instruction is (D). A., ADD, [BX], 01H, B., SHL, CL, AX C., OUT, 258H, AL, D., IN, AL, DX 5 point out the errors in the following instructions: (1) MOV, [BX], ES:AX AX cannot be used as the base register and the source, purpose cannot at the same time as the memory addressing mode (2) MOV, BYTE, PTR[BX], beyond the range of the number of bytes in a table (3) MOV, AX, OFFSET, [SI], OFFSET are used only for labels (4) MOV, CS, and AX are not allowed to assign values to CS by means of a transport instruction (5) MOV, DS, BP segment address can not be directly fed into data segment register 6.2 slice 8259A cascaded with the most manageable interrupt series (15). 7.4 slice 8259A, with the most manageable interrupts, and the number of direct interrupts is 29. What functions does 8.8259A have? Multiple interrupts can be connected. You can set the send interrupt type number. Ability to manage interrupt priority. Interrupt request mode can be set. 9.8086/8088 reads / writes the bus cycle, and the microprocessor samples the READY signals at the (T3) moment to determine whether to insert 10.8086/8088 has the minimum and maximum mode two modes of operation, when (MN/MX=1) is the minimum mode. The 11.8086/8088 control flag has (3) bits. 12.8086 in assembly language, process definition pseudo instruction is (PROC). The 13. output instruction produces the correct command sequence on the I/O interface bus (C). A. first sends the address code, then reads the command, and finally reads the data. B. reads the commands first, then the address code, and finally reads the data. C. t