数控车床(中级)（CNC lathe (intermediate)）.docVIP

数控车床(中级)（CNC lathe (intermediate)） CNC lathe (intermediate) training questions Fill in the blanks (1 cents per room, 1 x 60=60) 1. side knife, according to feed direction (B) two kinds. (A) forward offset knife, rear offset knife (B), left offset knife, right offset knife (C), upper offset knife, lower offset cutter (D), external offset knife, internal bias knife 2. programming with fixed loop instructions can be performed (B). (A) speeding up cutting speed, improving machining quality (B), shortening program length, and reducing program memory (C) to reduce the number of tool change, improve the cutting speed (D) to reduce the depth, quality assurance process 3. the instruction code for the auxiliary function of the machine tool switch is C. (A) F code (B), S code (C), M code (D), T code 4. when machining with constant wire speed control, the machined surface that has no effect on the surface roughness is (A). (A) arc (B) surface (C) cone surface (D) arc surface; 5. in the outer and outer circle fixed loop instruction G71, the value represented by F is the (D) value. (A) diameter (B), radius (C), length (D), feed 6. quenched and tempered heat treatment for various (B) carbon steels. (A) low (B), medium (C) high The 7. (C) program segment is the relative coordinate programming. (A) G01, X200, Z50 (B), G01, X100, Z10 (C), G01, U100, W-50 (D), G01, U100,, Z50 8., tool setting is (B) must do before the steps. (A) programming (B) machining (C), seeking coordinates (D), returning mechanical zeros 9. tool radius left compensation instruction is (C). (A) G39 (B), G40 (C), G41 (D), G42 10. when selecting a program, the CNC lathe operation should be performed in (B) mode. (A) automatic (B) manual (C) editing (D) zeroing 11. in the HNC-21T NC system MDI page, data entry must be used (B) mode. (A) edit (B), manual (C), automatic (D) entry 12. below the measuring instrument, there is no calibration is (D). (A) vernier measuring tool (B), screw micrometer gauge (C), micrometer g