从内浇口入手提高压铸模具的适应性（Improving the adaptability of the die casting die from the inner gate）.docVIP

从内浇口入手提高压铸模具的适应性（Improving the adaptability of the die casting die from the inner gate） [from the network, the main reference for learning] through the example from the gate area, orientation angle, discusses the relationship between gate and die adaptability, provides a way to solve similar problems in mold design and die casting production in the future. [Keywords] gate, die casting, adaptability The so-called mould adaptability refers to the same mold in different die casting machine, by different operators and parameters in a wide range of conditions, the production of qualified castings smooth degree and casting in the actual production process, there are many factors affecting the quality of die casting. Such as: injection pressure, injection speed, fast start position, furnace insulation temperature, mold temperature, mold structure, etc., which factors in these factors on the quality of the casting? In the die casting enterprises, it is a common view that the die affects seventy percent of the quality of the die castings, and the internal gate parameters play an important role in the adaptability of the die. A few examples are given to illustrate the influence of the mold gate on the dies adaptability and the treatment method. Effect of gate cross section on quality of die castings In a certain injection condition, ingate area is too large, will make the filling speed is too low, or even lead to premature solidification of metal filling; and too small ingate area, can make the jet intensifies, increase the heat loss, eddy current and involved in too much gas, the mold scour intensifies, causes the mold early retirement. In the area of the gate size, often by experience in the design drawing process to determine, simply on the basis of experience formula calculating the cross-sectional area of the gate, close contact separates the ingate sectional area and filling velocity and filling time, there is a risk of not effective matching between the ingate sectiona