如何才能正确选择机柜（How can the cabinet be properly selected）.docVIP

如何才能正确选择机柜（How can the cabinet be properly selected） Wiring cabinet: The server cabinet, people on the network cabinet is not very high, the general requirements of line hole to be big, a line is loose or wire loop, use cabinet base, the base line into the hole as much as possible. In front of the line, the 800mm should be equipped with a wide cabinet. The size of the inside of the cabinet shall be 19 inches, while the free space on the side shall be used for the line. The condition of the location of the wiring cabinet is not very good, the cabinet should pay attention to dustproof, and the cabinet body can not be exposed with metal to prevent corrosion. First of all, look at the use of your cabinet, use only two kinds of equipment cabinets (server cabinets) and wiring cabinet (network cabinet) Equipment cabinet: 1. equipment cabinet (server cabinet) In general, the equipment cabinets are made of international standard 19 inches wide, listing all equipment ready to be enclosed in the cabinet and its high, deep, and heavy weight. The heavier equipment is placed in the lower part of the cabinet (which makes the cabinet stand relatively stable). The total height of the equipment will eventually determine how many devices can be put into the cabinet. To have a certain gap between equipment and equipment, which helps the ventilation and cooling equipment, the highest layer on top of the device will leave some space for the future to replace the fan and better heat dissipation, high cabinets can be incorporated into more devices, so more local. The design requires the use of the cabinet after the end also set aside some spare space, because once you have bought and installed cabinets, some extra equipment often there have been no spare space reserved for system expansion, I have a headache Have net load equipment good strength, general requirements to use cold rolled steel (hot plate or strip stress is not enough, a long time will load deformation above the cabinet body