复印机最常见五类故障的 分析与解决（Analysis and solution of the five most common faults in copiers）.docVIP

复印机最常见五类故障的 分析与解决（Analysis and solution of the five most common faults in copiers） The world, whether in the mountains. Profound friendship a thousand feet deep, less than Wang Lun gave me love. Keep loyal and devoted to the last。 People have changed everything off, the first flow of tears. Brambling yasutomo lofty ambition is. With the rapid development of modern information technology, the copier has been widely applied in the field of Party and government organs at all levels, large and medium-sized enterprises, financial securities and colleges, become a kind of indispensable office automation products. FT4000 series Ricoh copier is produced by Japanese Ricoh Co, has small volume and light weight, fast running speed, high cost, high degree of office automation and long service life and other characteristics, in the current domestic copier market occupies a large share. For the convenience of the user in the absence of professional and technical personnel and special maintenance spare parts case, able to independently carry out the daily maintenance and maintenance, combined with the authors practical work, summed up the experience of the common fault analysis and maintenance of FT4000 series Ricoh copier as follows, for your reference. Fault phenomenon 1: after using a period of time, the jam phenomenon often occurs when copying Analysis and maintenance: according to the fault phenomenon, can be analyzed from the following four cases one by one: 1. Check whether the roll is normal. The aligning rollers are positioned on the upper and lower sides of the paper, which are the rubber rollers that stop the paper out of the carton after a short pause and then push the paper forward. As you all know, the copier enters the paper feeding section after passing the paper feeding section, that is, the paper feeding passage of the copier. Paper guide to the conveyer belt wheel after used for a period of time will cause excessive wear of rubber aging, or because of poor surro