富士变频器通信资料（Fuji inverter communication data）.docVIP

富士变频器通信资料（Fuji inverter communication data） This article is contributed by lxwcys DOC documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. I. overview...... The largest component of 1 hosts can connect 31 - point corresponding to the number of inverter (according to the netizen said, because the communication data is 16 bytes If a large amount of data, the inverter units increased to more than 20 units, communication is not so stable may also need to close the PLC watchdog )...... According to the netizens said that early G11 does not support Modbus communication protocol, need to use Fuji motor in its own - RS485 interface on a detailed instruction manual format. From the beginning of the 06 years, G11 supports Modbus communication, by the user in the converter parameters in the U49 option is to use the Fuji motor protocol FGI-Bus or using Modbus RTU protocol...... FRENIC 5000 11 series uses a common communication protocol, the same host program can control all the 11 series of aircraft running (parameters may vary with the different models)...... Fixed length frames are used to make programs on the host side easy to develop...... Corresponding to the speed required operating commands and frequency settings, the use of selected transmission frame, can shorten the communication time. Two, frequency converter parameter settings...... And the main parameters of communication relating to the following settings (if the transducer in the process of communication problems cannot be set according to operation frequency of , that other parameters still have problems, then please parameter initialization parameter H03, and press the STOP key and the key is set to 1, then press the FUNC/DATA button to confirm later set the following parameters)...... In the example below, the inverter address is set to 2, communication format is set to 19200bps, the 8 N data, no parity, 2 stop