艾默生变频器检修经验（Overhaul experience of Emerson inverter）.docVIP

艾默生变频器检修经验（Overhaul experience of Emerson inverter） Fault code, fault type, fault code, fault type POFF input undervoltage E008 input phase missing E001 accelerates overcurrent E009 output phase loss E002 deceleration overcurrent E010 module protection E003 constant speed over-current E011 inverter overheating E004 acceleration, overvoltage, E012 rectification, overheating E005 deceleration, over voltage, E016 read and write fault E006 constant speed overvoltage E018 contactor not pull in E007 control power supply overvoltage E019 current detection circuit fault 1, current detection failure (such as E019, E001): (1) the control panel Q1 is bad. (2) 7840 bad: in the inverter when power, with dc gear, black 5 feet, red respectively 6, 7, 8 feet, the value of 2.5, 2.5, 5 for normal, otherwise 7840 bad. (3) bad: in the inverter power, dc gear, pick 7840 of the 5 foot black, red plate are respectively connected with the foot from left to right should be 2.5, 2.5, 2.5, 3.4, 1.5, 0, 1.6. If the value is wrong, bad boss: at this time can replace three small IC small bad in LMV393), if not good, small change. 2, display POFF: The driving plate POFF, CVD normal voltage should be measured 2.62.7, such as 1.9, R52, C36, R51, C37, cable in a bad, One of the electrolytic capacitors is the worst. In the case of motor operated POFF, the driver board transformer may also be bad. 3 、 bad buffer resistance: The buffer resistor and the filter capacitor are in pairs. If one is bad, the other is likely to be bad. The buffer resistance is bad, or it may be caused by that the relay does not pull in (the relay is broken or the control board is bad or the component on the circuit connected with the two is bad). Single phase input (220V) converter, with particular attention to: if no display or frying machine, is likely to access the three-phase electric (380V) caused by (observable fault records: the control panel whether the bus voltage changes from 310 to 540). The IPM