简谈毕业论文格式.docVIP

　　简谈毕业论文格式 简谈毕业论文格式 导读：3．篇眉和页码a.正文部分居中以五号宋体字键入“河北工程大学毕业设计说明书”或“河北工程大学毕业设计12345678910 附件 13 毕业设计说明书（论文）统一格式规定一、论文结构要求 毕业设计说明书（论文）应采用汉语撰写，依次为： （1）封面，(2)毕业设计任务 书，(3) 指导教师评阅意见、评阅教师意见、答辩意见（毕业设计答辩评语页） ，(4) 中文摘要， （5）英文摘要， （6）目录， （7）正文， （8）致谢， （9） 简谈毕业论文格式 导读： 论文” 。 其它部分如摘要、目录、致谢、 简谈毕业论文格式 导读：  标题 正 文 3． 段落及行间距要求 黑体小四号 宋体小四号 a.正文段落和标题一律取“固定行间距 20pt”，从其它文档粘贴公式时，如不能 正确显示，可取“最小值 20pt”。 b.按照标题的不同，分别采用不同的段前、段后间距： 标题级别 大 标 题 一级标题 二级标题 标题 要在一篇 简谈毕业论文格式 导读：h-overanalysistocalculationthepropertiesoftheCIB.Usingthecalculationprogram,thearticleanalyzestheisolationprosperitiesofdifferentkindsofCIB.ItarrivesattheconclusionsthattheCIBhasbetterisolationeffectsandcanbeusedmoreerits of the terits of its ponents. This article is mainly to test the hysteretic properties of the three kinds of bearings. Firstly, according to the characteristics of the bearings, this article designs the test program and tests the bearings. On the basis of the analysis of the test result, it can be concluded that the hysteretic properties of the CIB can be calculated by adding the hysteretic properties of LRB and SIB. It provides the basis for calculating the hysterical curve of CIB. Secondly, the article gives the definition of sliding loading ratio. Given different value of the ratio, it can form different kinds of CIB. In this article, it uses push-over analysis to calculation the properties of the CIB. Using the calculation program, the article analyzes the isolation prosperities of different kinds of CIB. It arrives at the conclusions that the CIB has better isolation effects and can be used more ost optimized posite isolation bearings. Keyinated rubber bearings; sliding isola 3 4 5 6 7 8 9 10 简谈毕业论文格式 导读：······································································II1绪论··········································································· tion bearings; posite isolation bearings; hysteresis curve 附录 2：目录示例 目 录 摘要 · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · ·