浅议材料成型及控制工程专业毕业设计(论文)外文翻译.docVIP

　　浅议材料成型及控制工程专业毕业设计(论文)外文翻译 浅议材料成型及控制工程专业毕业设计(论文)外文翻译 导读：材料成型及控制工程专业毕业设计(论文)外文翻译 中文2500字 本科毕业设计 翻译 学生***** 班 级：*****班 学 号：***** 学 院：材料科学与工程学院 专 业：材料成型及控制工程 指导教师：***** 副教授 2011年3月25日 Section 4 – Die Design and Construction Guidelines for HSS Dies General Guidelines for Die Design and Construction Draal binder pressure and press tonnage is necessary aintain process control and to minimize buckles on the binder. Dies must be designed for proper press type and size. In some cases, a double action press or hydraulic press cushion may be required toachieve the necessary binder forces and control. Air cushions or nitrogen cylinders may not provide the required force for setting of draaintaining binder closure if H.S.S. is of higher strength or thickness. Draetal floping. Drainimize metal pression in corners, as shoaterial may be necessary depending on the characteristics of the HSS, the s 3 4 5 6 7 8 9 10 浅议材料成型及控制工程专业毕业设计(论文)外文翻译 导读：材料成型及控制工程专业毕业设计(论文)外文翻译everity of the part geometry, and the production volume. A draent, such as chrome plating, may be remended for outer panel applications. Form and Flange Dies Part setup in form and flange dies must alloust be increased as material strength increases; 3 degrees for mild steels, but 6 degrees or more 1 for HSS. Punch radii must be fairly sharp. 1t for loay require larger radii, but keeping them as small as practical ust be held to no more than one metal thickness clearance to reduce springback and side and flange steels should be keyed or pocketed in the casting to avoid flexing. Flange steels should be designed to ust not be promised with light-weight die construction. High strength steel will require a stiffer die to resist flexing and the resultant part distortions, especially for channel or “hat-section” parts. This type of 3 4 5 6 7 8 9 10 浅议材料成型及控制工程专业毕业设计(论文)外文翻译 导读：材料成型及控制工程专业毕业设计(论文)外文翻译 part can also cause serious die damage if double blan