外文翻译原文-使用田口方法设计一个永磁操动机构真空断路器及动态特性分析.pdfVIP

This article has been accepted for publication in a future issue of this journal, but has not been fully edited. Content may change prior to final publication. Citation information: DOI 10.1109/TIE.2015.2494006, IEEE Transactions on Industrial Electronics IEEE TRANSACTIONS ON INDUSTRIAL ELECTRONICS 1 Designing a Permanent Magnetic Actuator for Vacuum Circuit Breakers Using the Taguchi Method and Dynamic Characteristic Analysis Chang-Hyuk Lee, Bu Hyun Shin, and Young-bong Bang, Member, IEEE Abstract— Permanent magnetic actuators (PMAs) are usually The main application of a PMA is the above-mentioned used for vacuum circuit breakers (VCBs) due to their fast linear vacuum circuit breaker (VCB), and therefore the research on motion and large holding force. As the holding force becomes PMAs is often performed in relation to VCBs. This research larger, so does the current capacity of the circuit breaker. can be categorized into two groups: research on PMA Producing a large holding force with the same PMA size is therefore important in PMA design. This paper presents a design characteristic analysis, and research on PMA design. method of a PMA for vacuum circuit breakers. To attain the First, research on PMA characteristic analysis was desired holding force under the restric