HAAS操作面板操作步骤及自动对刀系统应用.pptVIP

START-UP Loading a Program Setting Tool Offsets Setting Work Offsets Setting Offsets with VQC Probe Jog Probe to Part Enter T1 and press WRITE/ENTER Press HAND JOG Press .01 Jog down in Z-axis Jog X and Y axes to position Probe near part corner, just below the part surface. Press CYCLE START Return to VQC Press EDIT Press PRGRM/CONVRS three times Return to VQC Press EDIT Press PRGRM/CONVRS three times Other Features Note that this template should only be used for tools whose length can accurately be measured on a 1/2 inch disk. (Therefore it is not meant for a 2 in fluted end mill). After the program is placed in MDI you can Press CYCLE START and the tools will be automatically touched off. Go to the Offsets page and show the tool offsets entered there. This time we want to use Probe 1-9 for the Z Offset template. This menu will appear after the last data is entered. Select or create a new program Add code to the current program Go to MDI mode Or Cancel Press 3 to put the code in MDI. You could also arrow down to selection 3 and press WRITE/ENTER. WrkOfset = 54 Xwidth 4. (X and Y widths should be 1” less than stock size.) Ywidth = 3. Corner = 1. Press WRITE/ENTER after entering each number. Use the Jog Keys to select Axes to Jog. After program is complete, press OFSET and point out how the Work Offsets have been updated for G54. See previous slides, if necessary, for instructions on jogging to the part. You can point out the Z value entered in the Work Offsets. It will be a large negative number representing the distance of the part surface from Machine Zero. The Tool Length will be combined with this offset to give you the Z part zero for each tool. The easiest way to load a tool is by pressing the Tool Release Button on the side of the spindle. While jogging down to the shim, you should move the shim back and forth under the tool until the tool pressure stops it from moving. If you press any key after TOOL OFSET MEASUR other than NEXT TOOL the “N