单片机多功能电子密码锁.docVIP

 #include reg52.h #define uint unsigned int#define uchar unsigned char#define KEY P3????? //键盘输入端口#define No_key 20??? //无按键时的返回值#define lcddata P2?? //1602的数据输入端口 sbit?? lcden= P1^2;sbit?? lcdrs= P1^0;sbit?? lcdrw= P1^1;sbit?? light= P1^3;sbit?? light1= P1^4; uchar j ; //用来统计输入 个数的全局变量uchar aa; //用来在定时器中计数的 全局变量 uchar code table[]= Hello!;uchar code table1[]= OK!?????? ;uchar code table2[]=Enter please:?? ;uchar code key_table[16] = ????? { ?????? 1,2,3,10,??? 4,5,6,11,??? 7,8,9,12,??? 0,13,14,15????? };uchar password[]={2,0,1,0,9,3} ;?? //设定初始密码uchar save[6];???????? //保存输入的数据 uchar conflag ;?????????????????? //确认标志uchar lockflag;????? //锁键盘标志uchar startflag;???? //开始标志?? ??? void delay(uint z);??????????????????????? //延时子函数void wright_com(uchar com);?????????????? //写指令函数void wright_data(uchar date) ;????? //写数据函数void init();????????????????????????? //初始化void display_OK();??????? // 显示OKvoid delete();??????? //删除输入的最后一个数uchar keyscan() ;????? //带返回值的键盘扫描程序 void enter_code(uchar t);?????? //输入密码函数，把输入的数据存入数组中并在屏幕上显示相应的东西,void?? confirm();???? //确认密码对不对，把输入的数据与密码逐一对比，完全一样刚正确， void?? succeed_an();??? //输入密码成功时的 响应,void??? fail_an();???? //输入密码 失败时 响应 void??? lockkey(); ??? //锁键盘三秒void??? alarm();??? //发出警报声void?? reset();????? //复位函数void?? display_enter();??? //显示输入 void main(void){??? uchar temp; ?? init();??? while(1)?? {???? ????? if(lockflag)????? {???? temp=keyscan();?? // 锁键期间也要进行键盘扫描???? if(temp!=No_key) //重新记时三秒????????????????? {????? aa=0;??? //重新在定时器中计数????? } ?????? ??? }??? else????? {???????? temp=keyscan();?? //反复扫描输入，等待随时输入??????? ????? ????? if(temp!=No_key) //有按键按下才进行下面的操作??????? { ????????? if(temp==10)??????? {??????? reset();???????? startflag=1; //开始标志置位 ??????? } ?????? if(startflag)????????? {???????? ???? enter_code(temp);?? //每扫描一次键盘就要进行一次处理，保存输入的数值????????????????? if(temp==13)?? //按下确认键盘就要进行密码确认?????????? {????????????? confirm();??? //进行确认判断 ???????????? if(con